|Trans-Cal Industries has developed Adapter Plates that allow the technician to quickly replace existing or legacy encoder installations in favor of the new Trans-Cal SSD120-(XX)N series of altitude digitizer/encoders. These plates simplify the installation task by providing an adapter designed for the Trans-Cal unit, while utilizing the exisiting mounting tray. All adapter plates include stainless steel mounting hardware and are approved for installation under TSO-C88a and ETSO-C88a|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
A slightly modification was necessary for easy installation. Otherwise the product works as advertised.
TRANS-CAL ADAPTER PLATE AMERI-KING REV B
The thickness of the material does not allow it to mate with the existing Ameri-King mounting and the mounting slot is too wide for the existing Ameri-king mounting screw and the trans-cal mounting screw is is a larger gauge. I couldnt use it. A wasted 23.95.
Plate did not fit AmeriKing receiver as intended. The orientation, even if had fit, was wrong.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.