Developed exclusively for Aircraft Door Seals by a major chemical company, this phenomenal new wing walk coating reduces the chance of slipping when climbing up on the wing. Unlike the mundane wing walk coating found on most aircraft, ULTRA WING WALK is a fast-drying polyurethane-based semi-gloss black coating with fine particles of rubber that adds class to any plane. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Excellent
ULTRA WING WALK
I am very happy with the Ultra Wing walk paint I applied to my Ercoupe, really looks nice.
ULTRA WING WALK
This is a very course grained product. Suitable for flat as opposed to rounded surfaces.
ULTRA WING WALK
ULTRA WING WALK
ULTRA WING WALK
This stuff works great. Spend a little time on prep work, follow directions, and it works great. I used a paint mixer on my cordless drill, scrubbed the area with soap and water (wire brush on bare metal spots) masked it off, and painted it on with a brush. Looks great. *****
ULTRA WING WALK
This product is an excellent product, easy to use, excellent grip and durable if you take your time and properly prepare the underlying surface. Patience is they key. Patience opening and closing the can. Proper stirring. And patience letting it dry fully, which may take a bit longer than indicated in high humidity environments. Be patient, prep properly and you’ll have a great looking, functional finish.
ULTRA WING WALK
Fantastic product! Take your time, clean and prep the surface, apply the material evenly, and you’ll be quite pleased with the result. We did not remove the old wing walk. We used a roller to apply the product and applied two coats. The result looks like new. Tough, and slip resistant. Will use it again!
ULTRA WING WALK
This stuff is great! We used a single 1 Qt can to re-furb the wing walks on a pair of low wing singles. The can is almost impossible to open (there must be a trick, I resorted to turning it upside down and using a can opener) and you need an assistant to keep stirring it constantly, but it goes on well, does not run, and the little chunks are VERY even. It dries with a beautiful liquid sheen and is very secure under foot when dry, a little slippery with wet shoes. But speaking of water, water sheets off it like magic and it is easy to clean. Im super happy with the product.
I bought this to redo the wing walks of my Grumman AA1-A and it worked beautifully. The wing walks now look pretty much like new. It was very simple to apply as well.
ULTRA WING WALK
Please note, Pilotshop.com's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop.com assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it can be adhered to metal.
This material works well for any application that an anti-slip wing walk is required.
Per the supplier: Yes, it can.
Yes, a standard paint brush (not included) is used to apply the wing walk coating.
Per the supplier: No other product is required.
Per the supplier: 1 quart will generally cover a flat surface of 15 sq ft with two coats.
The recommended application range is from 33° F to 95° F. It can be applied with a brush or a standard 3" roller.
Per the instructions: 1-3 to the touch. Ready to use in 9-12 hours.
Per the instructions: Normally one coat is all that is needed. If you wish to apply two coats, allow at least one hour between coats.
Yes, we have added it to the web page in the 'Documents' tab. Please review it there.