|Description||Mount No.||Part Number||Price / Each||Buy|
|Lord Elastomeric Engine Mount||J-12390-1|
|Lord Elastomeric Engine Mount||J-12453-1|
|Lord Elastomeric Engine Mount||J-12453-2|
|Lord Elastomeric Engine Mount||J-14290-4|
|Lord Elastomeric Engine Mount||J-15198-1|
|Lord Elastomeric Engine Mount||J-15198-2|
|Lord Elastomeric Engine Mount||J-3608-1|
|Lord Elastomeric Engine Mount||J-3804-15|
|Lord Elastomeric Engine Mount||J-6545-1|
|Lord Elastomeric Engine Mount||J-6545-6|
|Lord Elastomeric Engine Mount||J-6984-64|
|Lord Elastomeric Engine Mount||J-7402-1|
|Lord Cowl Mount||J-7444-14|
|Lord Cowl Mount||J-7444-24|
|Lord Cowl Mount||J-7444-36|
|Lord Elastomeric Engine Mount||J-9613-12|
|Lord Elastomeric Engine Mount||J-9613-31|
|Lord Elastomeric Engine Mount||J-9613-42|
|Lord Elastomeric Engine Mount||J-9613-49|
|Lord Elastomeric Engine Mount||J-9613-54|
|Lord Elastomeric Engine Mount||J-9613-58|
|Lord Elastomeric Engine Mount||J-9613-59|
|Lord Elastomeric Engine Mount||J-9613-72|
|Lord Elastomeric Engine Mount||J-12453-6|
|Lord Elastomeric Engine Mount|
see * for models
(includes: 2/J-9613-49 & 2/J-9613-72)
Note: Please review application guide below to confirm correct part number for your aircraft.
Lord Engine Mount Application Guide (PDF)
These compression type couplings consist of bonded rubber joints pressed into the sockets of metal hubs. These dynafocal engine suspensions provide proper flexible support to isolate engine vibrations and reduce noise transmission to airframe structure in all aircraft applications. Careful design assures maximum strength to hold the engine under ultimate load and emergency conditions. Suspensions also distribute loads in most desirable patterns, control engine motions, accommodate thermal expansion and manufacturers’ tolerances.
Very good mount
I replaced my 25 year old mounts on my 172 with these and the difference was amazing! On the first flight you could feel the difference with all vibration smoothed out. Great product!
They work fine, but the service life is rather short. I have to replace them every few years. At more than $ 20 per mount and 10 mounts in the cowling it is a considerable expense. I feel that there should be more durable materials available at the current level of technology.
Quality mount but very poor description of diameter and sizing for trying to build custom engine mounts!
The are priced and sold individually. So if your aircraft requires Qty 4, then you will need to purchase Qty 4 of the correct part number.
Yes, Lord mount J-12390-1 for example, has 2 halfs and a spacer.