The Gretz Aero Pitot Tube Mounting Bracket Kit is designed to be installed on all of the very popular Van's RV aircraft series, but it can also be installed easily on other metal wing aircraft,. as well as composite, and tube and fabric aircraft with very minor modifications to the kit parts. Once installed, this Pitot mounting bracket system is very easy to remove and to re-install. The mount brackets comes with in a paintable finish. These Pitot Tube Mounting Bracket Kits include the following: Mounting Bracket Laser cut Backing Plate Laser cut Washer Plate All mounting screws, nutplates and rivets Complete installation instructions with photos Paintable Finish Pitot Tube Mounting Bracket Kit for GA-1000, & GA-500, also, AN5812, PH502-12CR, Dynon, and Fly More, use (PN 10-01820) Paintable Finish Non-Drilled Pitot Tube Mounting Bracket Kit for Falcon, use (PN 10-01188) Please Note: Pitot tubes are Not included in Kits or Kit prices! |
Works great to mount a Garmin GAP-26. Order the one with pre-drilled holes. It is worth the extra cost. You may have to slightly change the mounting plate to fit your install. But no big deal for the average builder.
I thought undrilled meant that the base was undrilled. Now I see it’s the screws that hold the pitot are undrilled. Would have ordered otherwise if knowing that.
Simple and Rock Solid install, with a Garmin GAP 26. I would do it again....
Delivered as expeditiously as expected. It is still a few weeks until it is installed and 8 months until it is flown.
Well made, but I did have to polish down the inside of the mast as it had burrs that hung the wiring of the Dynon Pitot when it was inserted. No harm, but could have been bad.
The Gretz bracket is designed for Vans aircraft. The bracket is not chromed. It is an unpolished metal ready for paint.
Yes, the Gretz bracket is recommended for the GAP 26.
Per the manufacturer: From the bottom of the wing it is 3.75 to the mounting holes for the Pitot. Most Pitots will have a shank that extends down to the center of the entrance to the incoming airstream. This shank measurement may vary with the manufacture of the Pitot tube. Measure the distance of the mounting holes of the Pitot, to the center of the incoming airstream, add 3.75 and you will know how far the Pitot will be below the wing.
This is 4130 Chromoly Steel.
Yes, the PBK-12 will work with the Dynon heated pitot/AOA.
Yes, both the drilled and undrilled version will work with the GAP 26.
The washer plate has a length of 2.5 inches from center to center. and the width is 1.37 inches from center to center. The plate has holes for a #8 screw. We recommend purchasing the part to make sure you measure correctly on your aircraft.
Approx 0.50 lbs.