REGIONAL WAREHOUSE NETWORK FOR RAPID DELIVERY | 877-288-8077

Rochester Oil Gauges - Adapter Nuts

$12.90/Each
Quantity
Add to Wishlist
Part# 44-0024
MFR Model# 0044-00572

Overview

Rochester oil temperature gauges adapter nuts.
5/8-18UNF x 5/8-18 UNF.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Did not need the adapter

Michael W Verified Purchase

ROCH ADAPT NUT 5/8"-18 44-0024

September 17, 2023

It worked fine.

Steve J Verified Purchase

ROCH ADAPT NUT 5/8"-18 44-0024

May 5, 2023

I bought this as a supplement to oil temp gauge 10-11900. Didnt need it as one comes with the gauge. Its was helpful as I brought it to Home Depot to find a pipe thread plug to fit the end and used the plug as an oil drain plug during the gauge exchange and only lost one drop of oil. I could have used the one that came with the unit for the same task but didnt know it at the time and was trying to save on shipping

Phillip H Verified Purchase

ROCH ADAPT NUT 5/8"-18 44-0024

March 25, 2023

AAA+

Alexander F Verified Purchase

ROCH ADAPT NUT 5/8"-18 44-0024

August 31, 2022

Arrived quickly! Off and running again!

Phil D
June 22, 2020

This adapter nut has the correct conical seat inside for the Rochester temp gauge instead of the flat seat required for the former Scott temp gauge which the Rochester is supposed to be a replacement for. There was a service bulletin issued at one time for the change in the gauge probe and the requirements for the adapter nut. The requirement for the conical seat was not mentioned in the catalog neither was the requirement for a gasket between this nut and the engine receptical that it screws into. I found that an AN900-10 or an MS35769-11 annular copper=asbestos gasket fits this requirement and fortunately I had one.

Wheelock E
June 6, 2020

As expected.

Chad W
June 9, 2018

The hole in this adapter is too small for the vintage temp sensors I have. Seems that it might only fit the Rochester bulbs. Use the other adapter spruce has listed. It is brass and fits everything.

Neal G
September 16, 2018

Q&A

Please note, Pilotshop.com's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop.com assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What is the diameter of the center hole in this adapter?

One side is .375" and the other is .580".