These should be included with the jacks. Work wonders.

Kenneth H Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

Perfect. I hope to improve audio by insulating all the jacks.

Steven W Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

This and the insulated flat washer work well together to solve the issue of my headphone jacks grounding out.

Bill H Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

Quick response and exactly as ordered. Well done.

E. Y Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

Perfect for replacement in old tube amps.

Patrice B Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

High quality jacks. Well made. High quality materials and workmanship. It could be part of the jacks where it supposed to be used. Oh well, greedy has to fit somewhere...

Lewis M Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

These work as expected. I get zero noise in my headsets with the jacks isolated. Took me a bit to figure out that you need a 7/16 hole for the shoulder to fit through the hole. At first I tried 27/64 drill bit, but that was too small. Next step was 7/16.

Scott R Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

The insulated shoulder washer and insulated flat washer combination make it easy to install Switchcraft headset jacks that are electrically insulated from the airframe and therefore more likely to provide clear audio reception and transmission, for pennies (but a lot in shipping, Aircraft Spruce!)

David W Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

I dont know how I lose these when removing interior panels, but I do... Gave in and bought a bunch to have on hand.

James H Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

This is what you need to isolate your intercom jacks. get both the S1029 and S1028 as a set.

Linn W Verified Purchase

SWITCHCRAFT INSULATED SHOULDER WASHER S1029

Fit perfectly.

Fit and worked perfectly.

Solved my noise problem while transmitting insulate your Mike jacks

In order to avoid feedback problems (squealing), the Use of this Shoulder Washer is a must if you start using ANR headsets. (No part of the Panel Jacks should make contact with the ground). And... since they were on back order, Aircraft Spruce shipped them to me a few days later without charging me shipping ! Impressive customer service !

Product was delivered as requested .

As ordered and prompt

As always processing and delivery prompt and efficient.

Too expensive

I got em, they work, too expensive

Only went down one notch because the photo does not match the actual washer (a lot). This caused me confusion when ordering. Not sure why I am writing this because I see you have gotten this feedback before (6 months ago) and you have not fixed it. :-)

The picture does not match the shoulder washer. Therefore its not clear that youre ordering the right part.

Way to nickel and dime us to death. Include these with the headset jacks would ya!