SAME DAY SHIPPING ON ORDERS PLACED BY 4 PM VIA UPS | 877-288-8077

AVERY POP RIVET DIMPLER 1/8"

$27.50/Each
Part# 12-00614
MFR Model# 1024

Overview

For dimpling in hard to reach places. Works with any hand pop rivet tool. Can be used over & over. Works for both 100 & 120 pop rivets. Extra nails included (Uses standard hardware store nails). 2 sizes available.
Note: The pop rivet dimplers show above are made with 100° angles, same as regular dimple dies. They will work with either solid flush rivets (AN-426 – 100°) or with pull type rivets such as a AVEX rivets (120°), etc. The dimple formed with these pop rivet dies will not be as ‘sharp’ as dimples formed with regular dimple dies. This is because you get more pressure with a squeezer or a hammer than with a pop rivet puller; however, the dimples formed with pop rivet dimplers are adequate for occasional use in tight or hard-to-use places.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Worked great

William R Verified Purchase

AVERY POP RIVET DIMPLER 1/8"

March 8, 2024

Does a good job

Richard S Verified Purchase

AVERY POP RIVET DIMPLER 1/8"

September 15, 2022

must have tool that worked well

John M Verified Purchase

AVERY POP RIVET DIMPLER 1/8"

October 20, 2021

I used both sizes, 3/32 and 1/8. Both worked well. No issues.

Chris P Verified Purchase

AVERY POP RIVET DIMPLER 1/8"

July 21, 2021

This is the only product that will dimple several of the holes in our assemblies. They work great!

Danny H
March 1, 2021

Fine product Jim, and sons.

Alois M
May 21, 2020

get both sizes, this is a required item for dimpling at the apex of any skin. Should really include more nails as they get chewed up by the riverter jaws and eventually break. Takes a bit of practice to use, but almost as crisp as my drdt2 when you really grip it good. One thing to note about nails are they are simply extruded metal with no consistent radius so some will fit through a #40 hole and some will not, its just a thing to keep in mind when you replace the included supply.

Josiah D
August 11, 2019

Great tool to dimple in middle of sheet.

Gary K
August 10, 2017

Works great for difficult to reach area where traditional dimpling means won’t work. Supplied nail shanks last 5-6 pulls each then fail sending the bottom simple die flying away to never be found again...

Adam C
March 16, 2019

Works as advertised. Good for hard to reach places. Not as crisp as a conventional dimpler but better than no dimple.

James W
December 6, 2018

Q&A

Please note, Pilotshop.com's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop.com assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Whats the right nail size for part # 12-00613? Both nails that came with mine have broken, and now I need to get replacements.

The dimensions of this nail is 1.97" length and .091" OD.

Q: Will this work with traditional pop rivet tool, or is a special squeezer required?

It will work with any hand pop rivet tool.