|This J-3 fuel valve includes a steel handle for use with the original pushpull shut off control. This valve is a significant improvement over the original brass style fuel valve. The new valve has a stainless steel ball seated in an inert composite seat. This improved design eliminates the stiff operation and leaking around the shaft that the original design was prone to. PMA approved. Uses 1/4" NPT fittings.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Great replacement part to stop leaking valves from original hardware
PIPER J-3 FUEL VALVE
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
1. The overall length of the valve is 2 inches.
2. The length of the lever is approximately 2-7/8 inches.
The weight is 0.44 lbs.
This handle has a throw of 45 degrees.
The valve does come with a PMA tag on it. As far as the flow, it equals or exceeds the original valve flow. There is a stop build into the handle so it does not open all the way.
This will be about 2.125" top to bottom of valve.