Adustable plastic ventilators for use as fresh air intakes or air exhausts. Easily installed in plastic windshield or metal cowling.
Model A-2-100: Mounts in a 2” diameter opening. Can be turned to provide any degree of ventilation. The “Off” position is with the opening downward.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
arrived fast and installed effortlessly!
Works as advertised
I busted one of my vents when the door snapped up in the prop blast and it cracked against the underside of the wing. These replacements arrived very quickly and snapped right in place. They provide a lot of air in the cabin for such a simple device.
Great value for the money, easy to install and work well
very satisfied with product. good quality. works well . quite impressed. thank you very much
Easy to install provides lots of air
Nice vents work good
Indeed, they are 2,5 inches in diameter, not 2 as advertised. For those who are replacing an old 2 vent, its worthless.
2.5 in in diameter, not 2 inches, basically useless and not worth sending back for such a small refund. Rip-off
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These snapvents are priced and sold as a pair.
Per the vendor they don't actually close. You rotate the opening down and they stop scooping in air. So they are not flush and they are not able to be closed.
You would drill a 2" hole in the window to install, but the vent itself is slightly larger. You squeeze the vent to install it into the hole.