TSO'd Seat Belts & FAA Approved "Y" Harness Combination. Set includes one Cat. No. H-701 series seat belt with 3 bar slide and one Cat. No. H-702 series "Y" type shoulder harness with metal to metal hardware. |
![]() |
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov |
Very nice quality. Lap belt did not work for my application unfortunately (wide rear seat citabria) - too short on the length. Came with 3 bar slides and instructions to reuse existing OEM hardware. Nice setup, wish the seat belt was longer for a more universal fit! Double adjustment would be nice on the lap belt as well.
SEAT BELT/HARNESS KIT h858-001 BLACK
Worked perfectly in my 47 bonanza!
Perfect seatbelt and shoulder harness for my 47 Navion application. Good quality and price.
These belts are basically a good buy compared to the high-end harnesses. Pretty easy to install and adjust and good quality material. But the negative is that you need to thread the metal tip of the lapbelt hrough the 2 eyelets of the shoulder belts. Theres gotta be a better way to connect things together!
SEAT BELT/HARNESS KIT H701-009 SILVER GRAY
Very good
SEAT BELT/HARNESS KIT h858-001 BLACK
Worked well in my 1947 taylorcraft
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Depending on the aircraft there are different ways this can be installed. One way, if you have a head bar, you can mount this around a tube above the head bar. Another way is you can drill a hole in the spar and use a triangular fitting (does not come with harness) along with lubing a 3 bar slide (comes with harness) and put everything together. With each aircraft it may be different, so different hardware may need to be purchased depending on the application.
Per the manufacturer: You would use the existing hardware that was on your origional seat belt harness.
These harnesses are FAA TSO Approved but not STC'd for specific aircraft types. You will need to verify with your A&P that these can be installed in your model/make.
These belts only adjust at the buckle on one side only.
These belts are tagged with FAA-PMA on the label.
The longest length on the shoulder harness is 79 and the longest length on the seat belt is 62.
The harness comes with 1 3 bar slide and the belts come with 2 3 bar slides.
The width of these belts is 2".
Our part # 05-06225-2 is the black version.