If a new transponder is on your "to-get" list, you might want to choose one that's both relevant now and in the future. The KT 74 transponder from Bendix/King is the easiest upgrade for the popular KT 76A/C and KT 78A models, with a 'plug and go' capacity. And it's ADS-B compliant, therefore meeting all 2020 requirements. It is low-cost, easy to install and fits into your existing panel. Suiting your needs now and in the future.
KT 74 ADVANTAGE
Peregrine STC no longer required per latest software revision.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
I did not want an add-on to my old transponder, as it could die at any time. I already had a GNS430W as a GPS source, so the KT74 made sense as the least expensive ADSB transponder available. However, dont let the slide-in replacement idea fool you, ADSB-out capability has a significant installation effort/cost. This unit is actually designed and built by Trig, but I prefer the buttons on the King badged version for entering codes. Once installed the unit works fine.
Great transponder, great price couple it with a new digital encoder and its even better. What they dont tell you is it needs to be coupled with the Peregrin airspeed switch and all the work needs to be done at a 145 Avionics shop that sells Bendix King to get the STC. In an age where we talk about PART 23 reform for the added safety and reduced cost to the aviation community we take a step backwards with how this STC is listed. What does a customer do when there is no facility nearby?
If you already have a WAAS GPS, this best way to Comply. If not look at UATs.
Works great. This is one of the more affordable ways of becoming ADS-B Out compliant if your plane already has an approved WAAS GPS (such as a GNS430W). If you have an older rotary-dial transponder then youll find this to be an especially welcome upgrade.
About four months after installing a Uavionix tail cone ADS-b out, my KingBendix KT76 died while in flight. So instead of buying a used KT76 for few hundred bucks I spent just over $2,500 for the KT74. As a slide in replacement for the KT76, it does just slide in, but dont over tighten the 3/32nd allen screw, the locking piece is plastic. I would have given this five stars for the ease of installation, it did just slide in and work, but the installation manual is near impossible to find (Needed if you do the whole install with ADS-b out with other components). At a later date if I want ADS-b in, or have this transmit ADS-b out (On 1090es for international flights like to Mexico), youll have to install a different radio rack (Which came with this radio along with a plug) and you have to add more components, such as the king KGX 150R (Receiver with ADS-B Traffic and Weather) and an integrated WAAS GPS antena. That will set you back another three grand, I think it will transmit to a tablet too after you install this. So for now, its just an expensive replacement for my broke KT76, When my Uavionix Tailcone Ads-b-out stops working Ill spend the money for a gps antena and use the KT74 ADS-b out function. Bottom line, it did just slide in and work, problem fixed! Took 30 minutes to install and I was flying again. In the box it said, Made by Trig so go figure, its probably compatible with Trig products.
Display difficult to read in sunlight even on brightest setting, also screen to reflective needs to be matt finish not gloss.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Although the KT 74 transponder cannot be operated in individual modes, it responds to both legacy Mode A/C interrogations and to Mode S interrogations from both ground radar and airborne collision avoidance systems.
No it is not as the KT 74 is only a slide in replacement for the KT 76A/C and KT 78A model transponders. However, it is very similar and a good choice when upgrading because it minimizes the installation effort.
TIS-B reception requires an ADS-B In device, also referred to as a UAT receiver (978 MHz). Neither the KT 74 nor GTX 330 receives ADS-B In. With the optional BendixKing KGX 130/150 TIS-B can be displayed on a Garmin 430W (Intruder only).
Traffic information associated with ADS-B In known as TIS-B requires a UAT receiver (978 MHz) like BendixKing’s KGX 150R. Traffic and weather can be displayed on portable devices (for example, tablets with Foreflight) with the KGX Wi-Fi adapter. Note, light aircraft has no requirement to display traffic.
The KT74 includes an altitude monitor function that can alert the pilot to altitude deviations in cruise flight. It will alert when the pressure altitude differs from the selected altitude by more than 200 feet. The altitude alerter output, on the 12 way secondary connector, is switched to ground when the altitude deviation is detected and can be connected to a warning light or sounder to warn the pilot.
Yes, the KT 74 is 1090ES compliant (note it will still require a certified WAAS GPS source). Further, the KT 74 Mode S transponder is an ED-73E and DO-181E, Class 1 compliant, Mode S Level 2es datalink transponder, with support for extended squitter, elementary surveillance and surveillance identifier codes. The KT 74 is also a DO-260B Class B1S compliant ADS-B out participant.
No, it will not. The optional BendixKing KGX with Wi-Fi adapter will display traffic and weather on portable tablets, however, it is not compatible with the Aera 796 portable.
The KT 74 does not require a GPS antenna for standard installations. For ADS-B Out compliance it requires an input from an approved position source (WAAS GPS) in the RS 232 format. Per the STC, approved GPS sources include BendixKing KSN 765 & KSN 770, BendixKing KGX 150, Garmin GTN 6XX/7XX & GNS 400W/500W series (including GPS 400W & GNC 420(A)W), NexNav Mini 21000, and FreeFlight 1201.
Yes, the C172E is included on the AML STC along with hundreds of the most popular general aviation airframes.
Per the KT74 manual, the transponder is only capable of the 1090MHZ frequency.