|410 Microlight™ is the ideal low-density filler for creating a light, easily-worked epoxy fairing compound especially suited for fairing large areas. Microlight mixes with epoxy with greater ease than 407 Low-Density filler or microballoons and is approximately 30% easier to sand. It feathers to a fine edge and is also more economical for large fairing jobs. Not recommended under dark paint or other surfaces subject to high temperatures Not recommended under dark paint or other surfaces subject to high temperatures.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Nice filler for non structural
WEST SYSTEM 410 MICROLIGHT 5 OZ
Im using this with the West slow epoxy for fairing work on my RV10. Works great on joints etc. Make sure to get to peanut butter consistency or it will run a bit. Easy to sand and shape, again another great product, easy to use, clean up etc.
I have used 2, 5 oz cans so far. Easy to apply and sand.
Lighter than Super-Fill and much easier to sand than it or traditional micro, this is for those who want to get the job done with the least amount of time and hassle.
Easier to sand than glass balloons, this is the right stuff.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.