Perfect fit!

Shakeno M Verified Purchase

LW-13792 LYCOMING CRANKSHAFT OIL SEAL

Worked as advertised

Tom M Verified Purchase

LW-13792 LYCOMING CRANKSHAFT OIL SEAL

A+

Debra M Verified Purchase

LW-13792 LYCOMING CRANKSHAFT OIL SEAL

Works well with seal installer 5209. I reused the hook type retention spring, I wasn’t satisfied that the twist-lock spring would stay in place. If any crank seal surface cleaning is needed I would suggest 1500 grit or very light scotch bright.

William B Verified Purchase

LW-13792 LYCOMING CRANKSHAFT OIL SEAL

Perfect fit and seal on the IO-540 on my PA-24 260B

Jaison Verified Purchase

LW-13792 LYCOMING CRANKSHAFT OIL SEAL

Exact factory replacement seal.

Mark B Verified Purchase

LW-13792 LYCOMING CRANKSHAFT OIL SEAL

Great oil seal. The finishing and manufacturing features jumps out on your eyes way ahead from competition. It snapped right in after stretching it with the ATS tool. The only thing I did not like is the spring with the tread connection feature. I used the one with the hooks at the end from the other brand. Way easier to close the spring ring around the crankshaft. Run the engine for 7 minutes next day after 24 hours RTV seal curing. Works like a champ.

Works well. Follow lycoming instructions for installation. Be sure to properly prepare crankcase before installation. Must be properly cleaned so glue will adhere.

Install the spring on crank/prop shaft after seal bore is prepped but before the seal is stretched over the flange. Stretch the spring evenly and smoothly over its whole length just enough to screw the ends together. Then stretch the seal over the flange and work the spring into the seal groove.

Follow Lycomings Service Letter for installation. The new spring is a screw in connection. I found it impossible to reconnect because my fingers were to big to fit in the space between the crankshaft flange, new seal and the case. I reused the old hook style spring which installed easily. So my advise is dont wreck the old spring when removing the old seal