SAME DAY SHIPPING ON ORDERS PLACED BY 4 PM VIA UPS | 877-288-8077

INSPECTION PLATES

$2.65/Piece
Part# 09-19300

Overview

DOMED - Concave aluminum snap-type plate has single clip riveted across full diameter. Snaps to the ring at two contact points. Plate is 4-3/4" dia.

RECESSED - Recessed center and flanged-edge design will not creep off center due to vibration in propwash areas. 4-3/4" dia. x .020 aluminum. Will not twist or vibrate.

   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Joseph S Verified Purchase

INSPECTION PLATES

February 13, 2024

OK product. Ive used several on my plane. Occasionally lose one...

Robert K Verified Purchase

INSPECTION PLATES

January 19, 2024

Very good service

Maurizio C Verified Purchase

INSPECTION PLATES

October 10, 2023

Kenneth P Verified Purchase

INSPECTION PLATES

September 2, 2023

John B Verified Purchase

INSPECTION PLATES

June 22, 2023

Good

David W Verified Purchase

INSPECTION PLATES

June 7, 2023

Always loose one every now and then. Great to have extras on hand.

Skyline A Verified Purchase

INSPECTION PLATES

June 1, 2023

Easy to install with the rings (sold separately. Function as they should.

Peer E Verified Purchase

INSPECTION PLATES

November 22, 2022

5 stars! Well packed and received in excellent condition.

Jimmie W Verified Purchase

INSPECTION PLATES

November 20, 2022

Alex M Verified Purchase

INSPECTION PLATES

October 28, 2022

Q&A

Please note, Pilotshop.com's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop.com assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: How large (max and min) must the inspection hole be to use this part # 09-19300?

Minimum: 2.046" | Maximum: 4.146"

Q: What is the diameter of the cover plate?

4.75 inch diameter.

Q: Can these be used in metal aircraft?

The vendor does not have a specific application but they should work if they fit the hole.