|Features includes an all-steel construction, adjustable set holder (accepts all sets with 3/16" shank), and long handles for increased force. The yoke is made of the highest quality tool steel, and by simply removing 3 pins you can change the yoke to match your riveting or dimpling application.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
I needed an economical squeezer to dimple a small amount of holes on a RANS S-21 build. I didnt want to spend big money since there are only a few flush rivets on that kit. This is a simple design and sturdier than I expected. It got the job done quickly and precisely. I would buy again.
Item was just what I needed for my project, I had a question about adjustment before I bought. Got the answer and purchased the squeezer.
Great product and company experience. Delivered quickly.
Great product and delivered reasonably quick. Great company.
On time, worked as promoted. Well built and a very good value.
First one I got was not put together right and broke first time I used , glad you replaced it.
A bit lightly built, but working fine so far. Looks like a good value.
Worked as it should... Havent had long enough to make a rating..
ECON HAND RIVET SQUEEZER 2" WITH YOKE
Nice tool but absolutely no instructions on use. Very poor for a person new to riveting.
Squeezer is good quality but does not come with dies The die set sold here will not close the gap for thin material.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this would come with the 2" yoke.
The 12-01460 is sold with a 1" yoke included. It has a 1" depth clearance.
The ram that holds one of the sets rotates to adjust the set up or down. New units may be a little stiff, and require a small pin, or nail, to make the first few turns.
Yes, it will accept a die.