|5/32" (5/32" rivet)||.1560||3/8||12-03259|
Economy High Speed Steel 3/8" and 1/2" dia in 8 different sizes
• High Speed Steel • 1/4" -28 Threaded Shanks • 100° 3-Flute Precision Ground • For Use in Micro-Stop Countersink Units
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Used on 2024 and carbon plate. Worked fine
ECONOMY COUNTERSINK 5/32" x 3/8"
Used in conjunction with mirco-stop to countersink for rivets and tinnerman countersunk washers in fiberglass panels. Worked perfectly.
Good quality tool. You have to use it carefully, however, the middle piece can break and fall out if you move it left and right while using it. Little side movements are OK though.
Tends to load up with shavings and causes irregular beveled surface.
Because the base of the pilot has the sharp triangle cutout as seen in photo, only use this cutter in thick enough material to support the smooth surface of pilot, even at full depth, otherwise the thru hole will wallow out
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.