|Aircraft||Model||Barry P/N||Engine||Part No.|
|Cherokee 140, Warrior, Cherokee Six, Dakota, Saratoga, Saratoga S. P., Brave, Aztec C, F, Turbo Navajo, Navajo C/R, Navajo/Chieftain||PA28-140, PA28-151, PA28-161, PA32-300, PA28-236, PA32-301, PA32R-301, PA36-300, PA31, PA31-325, PA31-350||94011-02||*25000-7125641, *7225001 * Up, 0-320-E3D, All(Warrior PA28-161), *32-7240056 & Up, *0-540-J3A5D, All(Saratoga, S.P.), All(Brave), I0-540-C4B5, CIB5, All(Turbo Navajo), TI0-540-F2BD(L), TI0-540-J2BD(L)||94011-02|
Barry Controls has actively supported the general aviation market since 1981 and holds PMA approvals on a wide range of engine mounts. Barry mounts are warranted for 500 hours or 12 months and feature outstanding quality & value. Call for unlisted part numbers.
* Aircraft Serial Numbers
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
My parts arrived quickly and they were exactly what I needed. Thanks
Check the chart very carefully for the correct a/c model. Expensive but are better and cheaper than lord mounts.
worked perfectly on a Cessna 182P
Two out of the four mounts SPLIT on install! Terrible quality! Thank God we saw it split on install, and not discover it long after wed been flying. Quality control here was NOT in check on this run. Shame on the manufacturer for shipping this garbage.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Qty 1 mount is a single mount assembly, two halfs and a spacer. Qty 4 assy's are required for a complete installation.
No. They will only include the bushing. All mounting hardware needs to be purchased separately.
They are sold in pairs. The photo shown is how they will ship. Generally you will need for standard install.
These mounts are priced and sold individually. If you require 4 for your engine, you will need to order quantity 4.
Yes, that is correct.
This comes with 2 halves of a sandwich mount and a squared center piece.
No, this mount is FAA PMA approved and will come stamped with that approval. If you require an 8130-3 form, you will need to request it in the shopping cart at checkout. Additional charges will apply.
4 mounts would be required. Each mount has two halves for each mounting point.
150's have a different engine and require Lord J-3608-1 mounts.