Kelly ignition harness incorporate a negative-pitch spring design (the tip of the coil spring extends inward) allowing the coil spring tip to lie flat against the spark plug electrode, providing 360 degreee contact. Kelly ignition harnesses are FAA/PMA approved for Lycoming, Continental and Franklin engines. |
![]() |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
The harness(KA14004) fit my O-320-E2A perfectly with my slick magnetos. I would recommend this for others.
KA14004 KELLY IGNITION HARNESS RED
Good quality and easy installation. However, the leads wires were marked with a tape Top 1-4 and Bottom 1-4 which is fine but may rub off over time. I noticed on my old harness the nuts themselves were stamped with T1-4 and B 1-4 . Overall good product
KA14004 KELLY IGNITION HARNESS RED
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it is a complete harness (set of 2).