MyPilotPro Helicopter GoPro Mount

Select Size
SmallMediumLargeExtra Large
Add to Wishlist


The MyPilotPro Helicopter GoPro mount is designed to stand up to harsh conditions helicopters experience during flight including high G-force and extreme weather. They come in 4 sizes from 0.5″ diameter all the way through 2.5″ diameter. You can attach them to a wide range of tubular structure on your helicopter from the landing skids down to the smallest tube.

    Easily Attached and Secured
  • This Helicopter Mount comes with neoprene spacers which allow you to adjust the inside diameter over ˝ inch. The mount is very easy to attach to your landing skids or any other tubular structure. Simply place the neoprene spacers on the inside of the mount if any are needed, close the mount around your skid or tubular structure, and then snap the stainless steel bail latch in the groove. This process takes just seconds to accomplish.
    Once you have snapped the stainless steel bail latch closed, insert the included stainless steel cotter pin in its’ hole. This pin ensures the bail latch cannot come undone and virtually locks the mount in place where you have attached it. After you point your camera in the angle and direction you desire, tighten down the Swivel arm with the wing nut and then insert the other hairpin into the hole at the end of the bolt. This ensures your camera can not come loose in the Swivel arm.Your mount and camera are now securely attached to your skid or tubular structure.
    Versatile and Rugged
  • This Helicopter Mount is the most versatile GoPro helicopter mount on the market! It comes in 4 different size ranges to accommodate a wide range tubular structures including landing skids. You can use it with any action camera such as GoPro. We are an authorized partner of Ram Mounts® and use their 1″ Swivel ball in this mount. This allows you to point your camera in virtually any direction and angle imaginable.
    A lot of thought went into the design, materials, and structure of the Helicopter GoPro Mount. We wanted it to fit a wide range of tubular structures but also be rugged enough to stand up to anything the extreme conditions its’ meant to be used in can throw at it. We use stainless steel hardware and the mount body is tough glass filled nylon. This results in a mount that will last a lifetime in whatever rugged environment your adventures take place.


  • Securely locks in place
  • Glass filled nylon mount body
  • Stainless steel hardware
  • Neoprene spacers
  • Genuine Ram Mount® components
  • 4 sizes to fit 0.5″ thru 2.5″ diameter railing
  • 5.5 oz fully assembled
  • Lifetime guarantee


  • Small - 0.5” to 1.0” diameter
  • Medium – 1.0” to 1.5” diameter
  • Large – 1.5” to 2.0” diameter
  • Extra Large – 2.0” to 2.5”



Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.