Please review application guide below to confirm correct part number for your aircraft.
These dynafocal engine suspensions provide proper flexible support to isolate engine vibrations and reduce noise transmission to airframe structure in all aircraft applications. Careful design assures maximum strength to hold the engine under ultimate load and emergency conditions. Suspensions also distribute loads in most desirable patterns, control engine motions, accommodate thermal expansion and manufacturers’ tolerances.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
LORD RUBBER GROMMET J-3608-1
Perfect for my 1975 Cessna A150M
This fits C-150f model and others with Cont 0-200. 8 units are required and this part number is only for the rubber bushing. Bolts and washers not included. For my application I also needed 2 each AN6-54A, 2 each AN6-43A, 4 each AN960-616, and 4 each NAS679A6.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, these are conical mounts sold individually. 8 units required. Any other parts required are sold separately.
Top dia 1.36", Bottom dia 1.71". Top hole ID .52" bottom hole ID .97". Height over all .95", and .80 without including flange.