Flange mounted L-shaped model for under-the-wing mounting. 1/4" dia. aluminum tube.
Made in USA |
Product is as exactly as advertised and was sent out on time just don’t use the post office for delivery
Good quality, great for ultralights
This pitot has 2 globs of which will show externally. It could have easily been welded so it would be inside the wing. The mounting holes werent positioned well either. Ill be repairing it before installation. This is not the fault of Aircraft Spruce.
This pitot tube is made of 6061T6 aluminum.
The length on the long side with the flange is 9-34" total. The length after the 90* turn is 4-1/2". OD of the flange is approximately 1/2" and the flange sits 4-3/8" from the top of the tube.
The length on the long side with the flange is 9-3/4" total. The length after the 90* turn is 4-1/2". OD of the flange is approximately 1-1/2" and the flange sits 4-3/8" from the top of the tube. It is attached to the shaft.
Per the manufacturer:
1) thickness is .250.
2) 5/8
3) .136 +/- .005 DIA THRU HOLE, 100 DEG X .250 DIA, 4 X 90 DEG X 1.100 DIA
4) NO
5) .255 +/- .005
6) HOLES CONFIGURED FOR A .125 DIA MS20426 RIVET
7) The tubes are already bent to 90 degrees
8) No info
9) No info, the aluminum tubing is welded into place
Both ends of the pitot tube have a 1/4 inch OD.