|Part No.||Gauge Temp. Range||PN|
Temperature 2-1/4 Inch Electric Gauges
These electric instruments are lighted, allow easy installation, & feature a 2 year factory warranty. Order gauges and senders separately as shown. 12V operation unless other wise noted. Gauges fit 2-1/4" panel hole. For 24V operation, order P/N PE-111-4074 Resistors for each
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Good product, good com. with Mitchell
MITCHELL OIL TEMP 120-300 F
good informations about the product. Surprising rapidity of delivery! Packaging safe.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, both D1-211-5088 & D1-211-5090 are FAA PMA Approved.
Yes, the connectors are attached to the gauge.
No, it is not included. You can use 10-25175 or 10-25005.
There is not a harness included, you would need to make your own.
No it is not.
You must select a Mitchell sender that fits your engine.
No it does not. The manufacturer has the AML list on their website.
The sender is not included. You would use something like 10-25175 or 10-25005 and then run wire as long as needed.