SAF-AIR push type fuel drain valves are close tolerance valves of simple design. These valves provide the most trouble free operation of any other line of valves in the industry. SAF-AIR valves are manufactured with an o-ring placed on the stem to seal against a flat seat on the body. This design eliminates an area where dirt can gather, thus putting an end to the main cause of fuel drain valve drip. FAA & PMA APPROVED.
Note: Aircraft applications are for general reference only. Verify correct valve for your aircraft before ordering. MODEL CAV-110 1/8” NPT - For Cessna 310 tip tanks; Mooney Mark 20 and 20A; all Ercoupe models; Bellanca, Taylorcraft model B; Stinson 108, 108-1, 108-2, 108-3; Voyager model 10 and 10A; Navion; Waco VK series and UPF; and Sea Bee. Fits all standard gascolators. |
![]() |
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov |
SAF-AIR DRAIN VALVES CAV-110
Great.
SAF-AIR DRAIN VALVES CAV-110
Product was priced fairly, arrived on time , fit properly, and operates as expected.
SAF-AIR DRAIN VALVES CAV-110
Works as required
SAF-AIR DRAIN VALVES CAV-110
Had exact part I needed at fair market price. Really appreciate the cheaper shipping option to use First Class Mail for small items. Thanks. Ray
SAF-AIR DRAIN VALVES CAV-110
Replaced this on a Glasair 1. Had to use a fuel resistant O-ring at the base to prevent leaking (MS29513-110 FUEL RESIST O-RING Part #: 05-00111 Mfr Part #: MS29513-110). Works great now.
SAF-AIR DRAIN VALVES CAV-110
Use this on the Gascolator drain/sump. Works well, long life. Good product.
SAF-AIR DRAIN VALVES CAV-110
Had to use a rubber gasket underneath to stop a leak. This was a separate gasket/O-ring than the product comes installed with (the smaller one at the tip shown in the picture).
SAF-AIR DRAIN VALVES CAV-110
Fine but rusts for a pastime
SAF-AIR DRAIN VALVES CAV-110
Correct replacement for a Vans RV-7 fuel sump. Swapped it out for one that had a slight leak after twelve years. Followed others advice: left fuel in the tank and did the Indiana Jones swap, pulling the old one out and putting the new one in place with only a little bit of fuel getting on my hands.
SAF-AIR DRAIN VALVES CAV-110
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
It only needs the tip o-ring, part # MS29513-006.
No. The CAV-110 (05-01865) does not have a wire hole drilled into it for safety wire.
This would use a 1/2" socket.
You would need an an844-4 (steel) or -4d(alum) and an AN910-1(brass) of -1D(alum coupling.