SAME DAY SHIPPING ON ORDERS PLACED BY 4 PM VIA UPS | 877-288-8077

CHT PROBE, TYPE K

$71.75/Each
Part# 11-01023
MFR Model# CHT-510
DescriptionPart No.
CHT PROBE, TYPE K (Hose clamps not required)11-01023

Overview

**Note: Cessna probe CHT S2334-3 (06-00703) must be used with the new rochester gauges. Cannot be used with old Stewart Warner gauges.
   
California Prop 65 Warning Symbol

WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov

Reviews

Good but to short for my Project and i must return

David C Verified Purchase

CHT PROBE, TYPE K

June 26, 2021

Q&A

Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Can I use P/N AN5541-1 with P/N 10-00374? Thank you!

Yes, the AN5541-1 will fit into the 10-00374 CHT adapter.

Q: Are these probes grounded or ungrounded?

All of these Universal replacement probes are grounded.

Q: Are these probes grounded or ungrounded?

All of these Universal replacement probes are grounded.

Q: Will EGT probe # 11-01022 work on Insight GEM?

Yes, the Insight Gem uses a type K grounded probe.

Q: What size is the clamp on probe # 11-01022?

The clamp included is 1.56"-2.5". A 3.5" clamp can be ordered separately.

Q: How long are the wires on 11-01023 CHT probe? If I need longer what kind of wire should I use?

The wires are about 1ft long. To extend the leads, you will need type k thermocouple wire.

Q: Are the Universal type-K CHT probes compatible with JPI EDM-700?

JPI recommends using their probes on their engine monitors.