The Cylinder Head Temperature (CHT) - Tanis Adapter (Piggy Back) - probe, is installed in coalition with the Tanis Heating System. The CHT adapter probe will sit directly under the Tanis heaters, so that it may measure accurate and TRUE Cylinder Head temperatures. This probe can also be used to accommodate the factory supplied CHT probe as an adapter probe.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Haven’t installed this yet as the error code has gone away as quick as it started, but this is a 100% correct replacement for the original and I’m confident it will work as advertised. Very fast delivery.
JPI EDM OPTION CHT MM-113-3/8 ADAPTER PROBE GASKET TYPE
It works but reads a little low.
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes because this is a secondary system.Therefore the stock probe must be there.