Description | Part Number |
---|---|
Insulated Flat Washer (SWC S1028) Tan | 04-00975 |
Insulated Flat Washers Insulated flat washer for headset. microphone jacks. P/N 04-00975 1/32" x 5/8" OD x 3/8" ID Insulated Shoulder Washers Insulated shoulder washer for headset/ microphone jacks. P/N 04-00976 .032/.032 x 5/8" OD x .387 ID x .437 ID/step |
![]() |
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov |
SWITCHCRAFT INSULATED FLAT WASHER S1028
Perfect for replacement in old tube amps.
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
High quality jacks. Well made. High quality materials and workmanship. It could be part of the jacks where it supposed to be used. Oh well, greedy has to fit somewhere...
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
This is what you need to isolate your intercom jacks. get both the S1029 and S1028 as a set.
SWITCHCRAFT INSULATED FLAT WASHER S1028
Please note, Pilotshop's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, you will use the shoulder washer (04-00976) behind the panel with the ridge facing towards the front of the panel. The flat washer (04-00975) goes in the front of the panel. No part of the jack should touch the panel.
Both the mic and headphone jacks should have insulating washers on both sides of the panel.
The dims are 1/32" x 5/8" OD x 3/8" ID.